This will pull up the rollers so that the door sits in the track completely and finds leeway to get out of the frame.
Trimming out a sliding glass door.
3 attach the 1 6 door trim to the.
Use the phillips screwdriver to turn these screws counter clockwise.
Now lift the door up and out of the track use the screwdriver for this.
Create a sill pan to fit in the opening using roll flashing.
If this is the case it is recommended to put the molding up around your sliding glass door piece by piece.
2 cut and attach hardboard to inside of door frame this step is not applicaple if you already have smooth walls.
Things you ll need utility knife pry bar screwdriver hammer tape measure sliding glass door level shims or plywood strips optional nails flashing tape insulation optional.
Put silicone caulk around the edges of your opening where your siding and house wrap meet.
Diy sliding door trim 1 remove the baseboard where the door trim will be i measured out the width of the 1 6 and the 1 2 and used my handy.
You ll also want to put a few.
Press the wood trim flat to the edge of the sliding door opening and hold it there for several seconds allowing the epoxy to grip.
Secure the first piece with your carpentry nails.
Step 8 repeat steps 6 and 7 for the other edges fitting the wood trim to each other at the beveled edges.
In either case once you re ready to begin choose a side of the door to begin with and start lining the molding up in the exact spots you measured and marked earlier.